Equipements Emissions Testing Particulate measurement CAP3070

Particle counter
CAP3070

Name: Particle counter
Brand: Capelec
SKU: CAP3070

CAP3070 Capelec engine exhaust particle conter

CAP3070 Capelec Engine exhaust particle tester

CAP3070 Capelec exhaust PN counter17.12.2020 PTI PN Calibration Set24.05.2022

Engine exhaust particle measuring

METAS NMI PTB Approved

Reliable - Ergonomic - Fast - Low fouling - Low maintenance - Durable over time

CAP3070 is a exhaust particle counter cell based on Ext DC (Extended Diffusion Charging) technology.

It interfaces with the whole range of CAPELEC emission equipment. It can be used in addition to the gas analyser and smoke meter modules. It can also be supplied individually, driven by Windows.

Make a request

New Technology free of soot clogging
Low maintenance
New field of precision and sensitivity
No operation fluids required
Insensitive to vibrations & chocks
Easy to use
short (1m) or long (4m) heated probe (100°C)

Petrol & diesel emission

Connected

CAP3070 Capelec exhaust PN counter17.12.2020 PTI PN Calibration Set24.05.2022

A RELIABLE AND FAST MEASUREMENT

Further several years of research and specification within a European working group, Capelec has developed CAP3070, an innovative engine exhaust particle counter.

CAP3070PN uses a new technology without soot clogging, requiring little maintenance.

As well adapted to the needs of PTI as of Repair shops, it opens a new field thanks to a new technology.

The particle number measurement is based on the detection of nanoparticles : from 1 nanometer to 1 micron.
The wide dynamic measurement range ensures high measurement sensitivity and fast response time.
The soot-free technology requires little maintenance and allows continuous operation.
This new measuring cell complies with the European requirements for gas emissions.
The PASS/FAIL result is reliable.

ExtDC Advanced Diffusion Charging,
A new, accurate and sensitive technology

CAP3070 is an engine exhaust particle tester (PN) using Extended Diffusion Charging (ExtDC) measurement technology.

The counter works by electrostatically charging particles that pass through the sensor, then measuring the current caused by the charged particles leaving the sensor.

Extended Diffusion Charging technology offers obvious advantages:

no operating liquid is required
Insensitive to vibrations
independent of position during measurement
no dilution
no need for compressed air.

EXHAUST PN COUNTER

Measuring range 5 000 to 5 000 000 particles/cm3

Resolution of indication 1000 particles/cm3

Response time < 10s (T0 to T95)

Power supply 230 V

EXHAUST PN COUNTER

CAP4350 EOBD module

CAP8533 Vibration tachometer, RPM

New opportunities for garages : a fast use requiring little maintenance

The CAP3070 measures the particles without expensive maintenance for the user nor expensive consumables. The measurement is done at idle, without the need for free acceleration, polluting, noisy and stressful for both engines and operators.

Straight-through design keeps the sensor clean for extended run time.

Performed in less than 30 seconds, the procedure gives a clear indication of the condition of the filters: in good condition, cracked, or manipulated.

The use of the CAP3070 is simple and intuitive as it can be controlled from any terminal (computer, tablet, smartphone) under Windows.